…But I’mompletely lost around here… !!!
Probably over at the DIY Hardware and Software sub .Edit: Blue Hell has used the teleporter DJ–Last edited by DrJuste on Sun Feb 08, 8:57 pm; edited 1 time in total
But I’mompletely lost around here…
Yeah. LED’s won’t work well in this way. I allways get my most “brilliant” ideas at bedtime… they will onlylight up when on whh isn’t what I intended. They need separate resistors to ground before the swihes to operate properly.Before I had just one rate LED wired to give a little extra lux on step one. I liked that better but everyone else is doingblinkenlht all over and I had a Doepfer modular and it did that too!The problem with thisiuit is really that you probably want 16 steps and then it bomes just ridulously lots of swihes allover the ple. I intend to do a simple DR-55 like drum sequeer with an AVRiuit instead. If Ian find the time totake on the programming that is…Edit! Oops!hk the bottom right… youan’t wire two gate outputs together like that…
ok. I updated the Mro-Bop, reverting to the previous solution with a single rate LED and a 4019h at the output.I just one drawing and keep updating it,urrently rev. 3, otherwise you would end upruising between a lot ofhalf ready stuff…The rev. 3 should work. Thelk is tapped from two plesphases. The original state when the run swih is in stop position, is 0 onthe 4017lk input and 1 on 2D output. When you first hit run thelk will advae the 4017 from step 0 to 1and when thelk swihes states it will fire off a trigg pulse to the 4019.Edit! Just updated to rev. 3.1, unused NAND-gates used to pull one of thelk phases low to prevent the sequeerto fire off when you throw the swih to stop!Also, I’m not good with internet… You may need to hit refresh to see the latest rev. of the hemats.